top of page

10 Multi Urine Drug Test Dip Panel (Neutral Pack)

  • One step

  • FDA approved

  • 24 months shelf life

  • Perfect for workplace screening, insurance testing and forensic use purpose

  • Easy to read results

  • Results within 5 minutes

Model                       

Test Item

Test per Box

N-DOA510A

THC50/COC300/OPI2000/TCA1000/MET1000/BAR300/BZO300/BUP10/

MTD300/OXY100

20 tests

* For any customized combinations, adulteration strips, label design and mold design, please be free to contact us.

Specifications

10 Multi Drug Test Panel (10 Test Items) is a lateral flow chromatographic immunoassay for the qualitative detection of multiple drugs and drug metabolites in urine at a cut-off concentration.

 

The product is FDA approved, it is ideal for use in workplace screening, forensics, emergencies, detoxification treatment, addiction management treatment, transport authorities and custom and home use. 

How to use

Test must be in room temperature (50.0℉ ~86.0℉/10 ºC ~30 ºC)

  1. Open the sealed pouch by tearing along the notch. Remove the test device from the pouch.

  2. Hold the one side of the device with one hand. Use the other hand to pull out the cap and expose the absorbent end.

  3. Immerse the absorbent end into the urine sample about 10 seconds. Make sure that the urine level is not above the “arrow” marker printed on the front of the device.

  4. Lay the device flat on a clean, dry, non-absorbent surface.

  5. Read the result at 5 minutes. Do not read after 5 minutes.

result reading

Read the result

Positive (+)

One colored line appears in the control line region (C). No line appears in the test line region (T). This positive result indicates that the drug concentration exceeds the detectable level.

 

Negative (-)

Two lines appear. One colored line should be in the control line region (C), and another apparent colored line should be in the test line region (T). This negative result indicates that the drug concentration is below the detectable level.

 

Invalid

Control line fails to appear. Insufficient specimen volume or incorrect procedural techniques are the most likely reasons for control line failure. Review the procedure and repeat the test using a new test. If the problem persists, discontinue using the lot immediately and contact your local distributor with the lot number.

bottom of page